1950 E3 parts search

cmeador1984 · Veteran Member

1950 E3 parts search

thecoopkid · Senior Member

Phil Heisey has what you need. Some times he is slow to respond because he works a fulltime regular job and Cockshutt parts are a sideline. If you are in a hurry take your cores to your local auto parts store (a real auto parts store not a China crap store) and have them take them to their rebuilder.

Mike(NEOhio) · Senior Member

You can download a Buda engine service manual. Paste these links into your browser.

https://www.dropbox.com/s/li6usws23osuvgk/Budamanual_1thru27.pdf

https://www.dropbox.com/s/0k2w1jt1b4oz4fz/Budamanual_28thru54.pdf

https://www.dropbox.com/s/tjmkxkv6o5dxeki/Budamanual_lastpg.pdf

I'm working on scanning original parts books for the E3 and E4 COOPS and some original sales literature for COOPs and Cockshutts.

cmeador1984 · Veteran Member

Thanks folks! Will look at those PDF files when I get a chance, phone is a little slow to open them here at work. I'll get ahold of Phil about the other parts.

cmeador1984 · Veteran Member

Can anyone give me some info On the rear wheels? I would like to buy new rear rims but can't figure out what I'm looking for, I searched for cockshutt wheels as well as 38" 8 loop but have had no luck. So if née be I will buy bare wheels and weld the loops, I'm not sure what I am looking for though, or how to speck them.

Mike(NEOhio) · Senior Member

I have a '46 and '50 E3s. They used different rims but yours being a '50 should have the flat center rims. I have a rusted out rim that I can cut the lugs off of. They are riveted to the rim.

Cockshutt560 · Administrator

Here is a link to some 8 loop rims. I'd say you would need a 12x38 for 13.6x38 tire.

www.hayspear.com/product/CMRIMLOOPEDWHEELS/Tractor-rims-and-tractor-wheels-with-loops.html

cmeador1984 · Veteran Member

Thanks for the link, seems like that's what I'm looking for, however I was going to replace the tires with the original 11.2x38 or the current 12.4x38 I'm not so sire the original wheels are 12" wide, I'll have to measure. Just guessing I would say 10.5-11" but I'll check to see, thanks again.

cmeador1984 · Veteran Member

Is there anyone out here with the time to send me pictures of there E3 1950era I have began the year down and with some help searching for parts from Mr. Buttery (I think he's on here) I have began good success so far in my searches. However have found that quite a few parts are not original. I understand that the voltage reg and generator are not original, and realized that my grandfather has a makeshift hydraulic lever setup. Basically I want this thing to look as the day it left the factory and any help would be great. So if your willing to send me pics c.meador1984@gmail.com

Big areas are the generator side engine, dash area, hydraulics (really the plumbing from the pump. And lines as they travel to the rear. Thanks a lot ahead of time

cmeador1984 · Veteran Member

But I will take as many pics as your willing to send. As well as any you may have had during a tear down that may help me.